Operating - ICM
7/ 
Reset Area, distance and hours worked can
be individually reset to zero at any time. To do so, firstly select
the function that you wish to reset and then press and hold down the
reset button. The display will flash for a few seconds and will then
revert to zero.
8/ 
Metric / Imperial The ICM can convert any
displayed or stored information between Metric and Imperial units at
any time. A small chevron indicator at the bottom of the RH display
indicates which units are currently selected. To convert from one to
the other, simply press the Metric/Imperial button to move the
chevron between the MET & IMP indices below the display window.
9/ 
Fuel level The LH side of the RH display
operates like a conventional fuel gauge. Should the fuel level drop
to around 10 litres the indicator bar will flash and an audible alarm
will sound every 10 seconds.
10/ Ground
speed The forward speed is permanently
displayed in the RH window
Ground
speed alarm
Should the maximum
recommended forward speed (normally 30 mph) be exceeded the forward
speed display will flash and the audible alarm will sound.
Four
wheel steer alarm (if fitted)
The ICM provides
an output for the electronic 4WS control. This activates at speeds
above 12 mph. If the 4WS is not switched into "Road mode"
when this speed is reached an audible alarm sounds in the 4WS control
box and a visual warning illuminates.
11/ 
Temperature gauge The temperature display
in the RH window works like a conventional gauge. There is also a two
stage warning system built into the system to indicate engine
overheating. At the first stage, when the indicator goes into the red
sector, the indicator bar will flash and the audible alarm will
sound. If the engine continues to get hotter the audible alarm volume
will increase and "STOP" will flash in the LH display. The
engine must be stopped when either of the alarms sound to avoid
damage and the cause of overheating be investigated immediately.
12/ 
Clock Press this button to display the time
of day in the LH window
13/ 
Area override Press this button to override
the automatic cutout on the area meter. When you do so the
area/distance meters will stop recording, the chevron in the LH
display will flash and the L.E.D will illuminate on the override
button. This can also be used if an automatic cut-out is not fitted
to the sprayer/spreader controls.
14/ 
Workrate Press this button to show your
spot rate of work in the LH display window. This will show your
workrate in acres or hectares / hour as you are driving along.